Grizzly G0568 Owner's Manual page 62

5.
Loosen the guide post lock knob, lower the
guide post to within 1" of the table top, then
tighten the knob.
6. Place a machinist's square on the table next
to the right hand side of the guide post, as
shown in Figure 81.
Guide Post
Figure 81. Example of checking guide post
squareness.
—If there is no gap between the square and
the guide post along its full length, no
adjustments need to be made. Proceed to
"To check/adjust if the guide post is parallel
with the blade front-to-back."
—If there is a gap between the square and
the guide post, the guide post is not parallel
to the blade. Go to Step 7.
-60-
(Front View)
7.
Loosen each of the four screws shown in
Figure 82
1 ⁄ turn.
4
Figure 82. Guide post adjustment screws.
8. Gently tap the lower part of the guide post in
the appropriate direction until there is no gap
between the square and the guide post.
9. Tighten the screws shown in Figure 82.
To check/adjust the guide post parallel with
the blade front-to-back:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the guide post lock knob, lower the
blade guide assembly to within 1" of the table
top, then tighten the lock knob.
3. Remove the screws that secure the guide
post guard and move it up and out of the way.
Model G0568/G0569 (Mfd. Since 10/11)