Grizzly G0568 Owner's Manual page 54

Blade Tracking Knob
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the blade tracking knob:
1. DISCONNECT MACHINE FROM POWER!
2. Unscrew the blade tracking knob 5 turns.
3.
Wipe off any existing grease and sawdust
buildup on the threads.
4. Apply a few dabs of a light all-purpose grease
to the threads.
5. Re-adjust tracking (see Blade Tracking on
Page 25).
Table Rack and Pinion
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the table tilt rack and pinion
assembly:
1.
DISCONNECT MACHINE FROM POWER!
2.
With the table perpendicular to the blade,
wipe off all existing grease and sawdust
buildup from the rack.
3. Move the table up to its maximum 45˚ angle
and wipe (see Figure 73) off all existing
grease and sawdust buildup from the rack.
Figure 73. Example of lubricating table tilt rack
and pinion assembly.
-52-
4.
Apply a thin coat of light all-purpose grease to
the rack.
5.
Move the table up and down several times
to distribute the grease, then wipe off any
excess grease.
Trunnions
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the trunnions:
1.
DISCONNECT MACHINE FROM POWER!
2. Move the table up until it reaches its maximum
45˚ angle and wipe off all excess grease and
sawdust from the trunnions.
3.
Apply a very thin coat of light, all-purpose
grease to the trunnions (see Figure 74).
Figure 74. Trunnion lubrication location.
4.
Move the table down and then back up to dis-
tribute the grease, then wipe off any excess
grease from the trunnions.
Model G0568/G0569 (Mfd. Since 10/11)