Grizzly G0568 Owner's Manual page 31

8. Turn the bandsaw ON and allow it to reach
full speed, then press the foot brake (see
Figure 53, Page 40) completely.
— If the bandsaw blade stops the foot brake
is working correctly; continue to the next
step.
— If the bandsaw blade does not stop mov-
ing, the foot brake feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
9. Make sure the blade has fully stopped, open
the top and bottom wheel covers a few inch-
es, then turn the bandsaw ON.
— If the bandsaw does not start the upper
wheel cover limit switch (see Figure 34)
is working correctly; continue to the next
step.
— If the bandsaw starts, immediately turn the
machine OFF and disconnect power. The
upper wheel cover limit switch is not work-
ing correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
Figure 34. Upper door limit switch.
Model G0568/G0569 (Mfd. Since 10/11)
10. Close the upper and lower wheel covers.
11. Turn the switch disabling key to "0", as shown
in Figure 32 on Page 28.
12. Try to turn the machine ON.
— If the bandsaw does not start, the switch
disabling feature is working as designed.
The Test Run is complete.
— If the bandsaw starts, immediately discon-
nect power. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
13. Model G0569 Only: Verify that the power
is not connected out of phase by starting/
stopping the machine and determining if the
motor turns in the correct direction, using the
criteria below:
— If the blade moves down and toward the
table (as standing in front of the machine),
it is turning in the correct direction.
— If the blade turns up and away from the
table, it is turning in the wrong direction.
Stop the machine, disconnect the power
source, then swap any two of the three
power wires that connect to the machine.
-29-