Water Pump; Injection Nozzle - Kubota GL6000 Workshop Manual

GL6000, GL7000, GL9000, GL11000, WSM

(5) Water Pump

(6) Injection Nozzle

Thermostat Assembly
1. Remove the thermostat cover mounting screws (1), and remove
the thermostat cover (2).
2. Remove the thermostat assembly (4).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
side of the gasket (3).
(1) Thermostat Cover Mounting Screw
(2) Thermostat Cover
Water Pump Assembly
1. Loosen the tension adjustment screw, and remove the fan belt.
2. Remove the fan and fan pulley.
3. Remove the water pump assembly (1) from the gear case cover.
4. Remove the water pump flange.
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to the both
sides of gasket (2).
(1) Water Pump Assembly
Nozzle Holder
1. Secure the nozzle retaining nut (7) with a vise.
2. Remove the nozzle holder (1), and take out parts inside.
(When reassembling)
• Assemble the nozzle in clean fuel oil.
• Install the push rod (4), noting its direction.
• After assembling the nozzle, be sure to adjust the fuel injection
pressure.
Nozzle holder
Tightening torque Overflow pipe nut
Nozzle holder assembly
(1) Nozzle Holder
(2) Adjusting Washer
(3) Nozzle Spring
(4) Push Rod
1-S40
ENGINE
(3) Thermostat Cover Gasket
(4) Thermostat Assembly
W10393690
(2) Water Pump Gasket
W10395040
34.3 to 39.2 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 lbf·ft
19.6 to 24.5 N·m
2.0 to 2.5 kgf·m
14.5 to 18.1 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(5) Distance Piece
(6) Nozzle Piece
(7) Nozzle Retaining Nut
W1062045
KiSC issued 05, 2015 A