Check Point Of Every 200 Hours - Kubota GL6000 Workshop Manual

GL6000, GL7000, GL9000, GL11000, WSM

[5] CHECK POINT OF EVERY 200 HOURS

Checking Fuel Filter Element
1. Close the fuel valve (1).
2. Remove the fuel filter element (2).
3. After cleaning the fuel filter element (2), screwing it in by hand.
NOTE

• Check for fuel leak after checking it.
(1) Fuel Valve
Checking Radiator Hose and Clamp Bands
1. Check to see if the radiator hoses (2) are properly fixed every 200
hours of operation or every six months, whichever comes first.
2. If clamp bands (1) are loose or water leaks, tighten bands
securely. Replace hoses and tighten clamp bands securely, if
radiator hoses are swollen, hardened or cracked.
3. Replace hoses and clamp bands every 2 years or earlier if
checked and found that hoses are swollen, hardened or cracked.
(1) Clamp Band
Changing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the engine oil
filter cartridge.
1. Remove the engine oil filter cartridge (1) with the filter wrench.
2. Apply engine oil slightly to the rubber gasket of new cartridge.
3. Install the new cartridge, screwing it in by hand.
Over-tightening may cause deformation of the rubber gasket.
4. After the cartridge has been changed, the engine oil level
normally lowers a little. Add engine oil to proper level.
IMPORTANT

• To prevent serious damage to the engine, replacement oil
filter cartridge must be highly efficient. Use only a genuine
KUBOTA filter cartridge or its equivalent.
(1) Engine Oil Filter Cartridge
G-18
G GENERAL
(2) Fuel Filter Element
W1046058
(2) Radiator Hose
W1014590
W1015117
KiSC issued 05, 2015 A