Disassembling And Assembling; Cylinder Head And Valves - Kubota GL6000 Workshop Manual

GL6000, GL7000, GL9000, GL11000, WSM

[3] DISASSEMBLING AND ASSEMBLING

(1) Cylinder Head and Valves

Cylinder Head Cover
1. Remove the cylinder head cover screws (1).
2. Remove the cylinder head cover (2).
(When reassembling)
• Check to see if the cylinder head cover gasket is not defective.
Tightening torque Cylinder head cover screw
(1) Cylinder Head Cover Screws
(2) Cylinder Head Cover
Injection Pipes
1. Loosen the screws to the pipe clamp (1).
2. Remove the injection pipes (2).
(When reassembling)
• Sent compressed air into the pipes to blow out dust. Then,
reassemble the pipes in the reverse order.
Tightening torque Injection pipe retaining nut
(1) Pipe Clamp
1-S28
ENGINE
6.86 to 11.3 N·m
0.7 to 1.15 kgf·m
5.1 to 8.3 lbf·ft
[a] GL6000, GL7000
[b] GL9000, GL11000
W1028468
24.5 to 34.3 N·m
2.5 to 3.5 kgf·m
18.1 to 25.3 lbf·ft
(2) Injection Pipe
W1028640
KiSC issued 05, 2015 A