Servicing; Terminal Voltage For Each Part During Normal Periods (No-Load Periods); Stator Coil - Kubota GL6000 Workshop Manual

GL6000, GL7000, GL9000, GL11000, WSM

[3] SERVICING

(1) Terminal Voltage for Each Part During Normal Periods (No-load Periods)

(2) Stator Coil

Output Terminal
1. With the NFB in the ON position, measure the voltage in each
phase and each line.
2. If the factory specification is not indicated, inspect the output
circuit or the wiring harness.
(Refer to "5. WIRING DIAGRAM" (2-M8).)
Output voltage Factory spec.
[A] Terminal Type
Main Coil Winding
1. Test for continuity between coil leads with a milliohm meter.
Many kind of wiring have been arranged in the stator depending
on the voltage variation.
2. If the resistance is not as specified, replace the stator or contact
service station.
(Refer to "5. WIRING DIAGRAM" (2-M8).)
Resistance Factory spec.
* Measurement is not possible with a regular tester.
[A] G6000, GL7000
2-S20
GENERATOR
Rated voltage 7 or 8 %
[B] Receptacle Type
W1068933
Refer to "2. SERVICING
SPECIFICATION" (2-S6).
[B] GL9000, GL11000
W1026118
KiSC issued 05, 2015 A