Check Point Of Every 300 Hours; Check Point Of Every 400 Hours - Kubota GL6000 Workshop Manual

GL6000, GL7000, GL9000, GL11000, WSM

[6] CHECK POINT OF EVERY 300 HOURS

[7] CHECK POINT OF EVERY 400 HOURS

Checking Generator's Brush Wear
1. Check to see if the brush has worn to more than 1/2 below the
standard dimensions.
2. If wear exceeds the allowable limit, replace.
Standard
length
Brush length (Stretch out
of the Holder)
Allowable
limit
H : Brush Length
Checking Generator's Slip-ring
1. Check to see if there is no unusual wear and surface roughness.
[GL6000, GL7000]
Factory spec.
Slip-ring O.D.
Correction limit
[GL9000, GL11000]
Factory spec.
Slip-ring O.D.
Correction limit
(1) Slip-ring
Changing Fuel Filter Element
1. Close the fuel valve (1).
2. Remove the fuel filter element (2).
3. Install the new fuel filter element, screwing it in by hand.
NOTE

• Check for fuel leak after replaced it.
(1) Fuel Valve
G-19
G GENERAL
15.0 mm
All model
0.59 in.
GL6000, 4.5 mm
GL7000 0.18 in.
GL9000, 7.5 mm
GL11000 0.30 in.
W1037215
49.7 mm
1.96 in.
47.5 mm
1.87 in.
64.0 mm
2.52 in.
62.5 mm
2.46 in.
W1046346
(2) Fuel Filter Element
W1052658
KiSC issued 05, 2015 A