Ranger 9000E Installation Manual page 34

Locations 604-607: Closing Time
To enable the late-to-close report, a 4-digit, 24 hour closing time must be entered in locations 604-607. For example,
to enter a closing time of 6:30 p.m.(1830), program a "1" in location 604, a "8" in location 605, a "3" in location 606,
and a "0" in location 607. Factory default is a "2-0-0-0" which sets a closing time of 8:00 PM. NOTE: A
communicator code must be entered in location(s) 588-590 if this feature is selected.
Location 608: Closed Saturday Enable
A "1" should be programmed in location 608 if the installation will be closed on Saturdays and early-to-open or late
to close features have been enabled. A "1" will cause the early-to-open report to be communicated in the event an
opening is made on Saturday. Factory default is "0", and openings are allowed on Saturday within the assigned
schedule without creating a report.
Location 609: Closed Sunday Enable
A "1" should be programmed in location 609 if the installation will be closed on Sundays and early-to-open or late
to close features have been enabled. A "1" will cause an early-to-open to be communicated in the event an opening
is made on Sunday. Factory default is "0", and openings are allowed on Sunday with the assigned schedule without
creating a report.
Locations 610-615: Format Overrides (See Appendix)
Location 616: Programming The Hour For Autotest - Tens Digit
Location 616 contains the tens digit of the hour that the autotest report is initiated. The time is entered in 24 hour
time. If the desired autotest time is 5:25 PM, the 24 hour time is 17:25, so this location should contain a "1", which
is the tens digit of the desired hour for autotest. If the desired autotest time is 9:36 AM, the 24 hour time is 09:36,
and this location should contain a "0".
Location 617: Programming The Hour For Autotest - Ones Digit
Location 617 contains the ones digit of the hour that the autotest report is desired. The time is entered in 24 hour
time. If the desired autotest time is 5:25 PM, the 24 hour time is 17:25, so this location should contain a "7", which
is the ones digit of the hour for autotest. If the desired autotest time is 9:36 AM, the 24 hour time is 09:36, and this
location should contain a "9".
Location 618: Programming The Minutes For Autotest - Tens Digit
Location 618 contains the tens digit, of the minutes after the hour that the autotest is desired. The time is entered
in 24 hour time. If the desired autotest time is 5:25 PM, the 24 hour time is 17:25, so this location should contain a
"2", which is the tens digit of the minutes for autotest time. If the desired autotest time is 9:36 AM, the 24 hour time
is 09:36, and this location should contain a "3".
Location 619: Programming The Minutes For Autotest - Ones Digit
Location 619 contains the ones digit, of the minutes after the hour that the autotest is desired. The time is entered
in 24 hour time. If the desired autotest time is 5:25 PM, the 24 hour time is 17:25, so this location should contain a
"5", which is the ones digit of the minutes for autotest time. If the desired autotest time is 9:36 AM, the 24 hour
time is 09:36, and this location should contain a "6".
34