N8012 N-Command Controller - AMX SC-N8012 User Manual

N8012 N-Command Controller

The N8012 is built from a standard computer, but not all buttons, LEDs, and connectors are enabled. Refer to
Front and Rear Panel Descriptions table
Three solid-state hard drives (swappable)
N8012 Front and Rear Panel
FIG. 3
Front and Rear Panel Descriptions
TABLE 2
Front Panel
ON/OFF button
POWER indicator
HDD LED
Solid-State Hard Drives
Rear Panel
RJ-45 ports
- One on the N8001
- Two on the N8002 and N8012
Power Input
Power On/Off Switch
N-Command User Manual
on page 8 for hardware details on the N8012 N-Command Controller.
Power Inputs
Press to turn unit on or off.
For the N8001, the power button illuminates green when power is on. For the N8002/N8012 the power
LED turns solid (blue) when power is on.
On flashing (red) when there is software activity. (N8002 only.)
Three 128 GB solid-state hard drives that are configured in a raid configuration, allowing for swapping
in the event of failure. (N8012 only.)
ETH 0 (N8002, N8012):
8-wire RJ45 female. 10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch
port. Can be used to connect to a separate corporate LAN.
ETH 1 (N8001, N8002, N8012):
8-wire RJ45 female. 10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch
port. Must be connected to the network in order to provide device and user control.
N8001:
Comes with an AC power brick. Input is 120V - 240V. Output is 12V/5A.
N8002/N8012:
120 Volt AC power input for external power supply.
Use to apply or remove power to the unit from the power supply (N8002 only).
NOTE: This On/Off switch should only be used to disconnect the N8002 from main power once it
has been properly shut down. Use the on/off button on the front of the unit for proper shut down.
Chapter 1: Introducing Your New N8000
On/Off Switch and Indicators
Two RJ-45 auto-sensing
gigabit ethernet ports
(Eth0 on the left and Eth1 on the right)
Figure 3 as well as the
8