Safety Information - Rimage Prism CDPR11 User Manual

Safety information

This manual and the indications on the product allow proper and safe operation. The indication
marks below help protect you and other persons from injury, and equipment from damage.
Warning! According to ANSI (American National Standards Institute) standards, a warning is
used to indicate situations that could result in bodily injury to personnel operating or
maintaining the equipment.
Caution: Indicates that failure to observ
equipment, product, software, or data.
Safety precautions
Warning! Do not disassemble or use tools on the printer. All service procedures should be
performed by an authorized field technician, or s
with the power cord plugged into the AC outlet.
Warning! This printer has a voltage slide switch on the back of the un
printer, check that the switch is set to the correct voltage. Do not use voltage other than
110VAC or 220VAC. This could result in a fire and an electric shock.
Caution! All equipment with AC line voltage, or low DC volt
supplies, fuses, fans, non-stepper motors, must be replaced with Rimage–approved
components to maintain the safety approval issued by UL.
Caution! Do not reach inside the printer unless absolutely necessary. There may be sharp
edges on some metal parts.
Caution! Do not use the printer if it is overheating or an abnormal smell is detected. This ma
result in a fire and an electric shock. In case of heating or abnormal smell, immediately
disconnect the cable from the outlet. Contact your dealer for repairs.
Caution! Do not pl ace or store the printer in a location where children may reach it. Severe
injuries and equipment damage may occur if the printer is turned over or falls down.
Caution! Allow sufficient free space for opening the printer tray. Do not touch the printer tray
while it is moving.
110635_G
e this guideline could result in loss or damage to the
ent in for repair. Do not service the printer
ages, such as switches, power
Learn more
it. Before you use the
y
19