Toshiba e-Studio2505AC Hardware Troubleshooting Manual page 58

1.TROUBLESHOOTING FOR THE HARDWARE
 Misfeed when making copies or prints (using a drawer)
Clear the paper misfeed following the guidance shown on the touch panel.
1
Open the paper source drawer, check that the guide width is correct and there is no folded/curled
2
paper or overloading, and then close the drawer.
Be sure that the height of the stacked paper does not exceed the line indicated inside of the side guides.
In particular, be sure that the upper limit for thick paper is not exceeded when placing thick paper in the first
drawer of the e-STUDIO2000AC/2500AC. The amount of thick paper you can load in the drawer is lower than that
for plain paper.
3 Close all the drawers or covers.
4 Press [Yes] when "Cancel print job?" appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper in the drawer with that corresponding to the size set in
the equipment after the paper misfeed is cleared. Then if you press [No] in step 4, the job can be restarted. In this
case, it is not necessary to follow step 5 and later.
58 Clearing a Paper Misfeed