Trane Tracer Summit Hardware And Software Installation Manual page 165

Chapter 6 Network Wiring
BCU DIP Switch (S2)
Location
UCM communication
card slots
Operator
display socket
High capacity
card slot
Standard capacity
card slot
150
Trane recommends that the first BCU device start at address 01 and that
all additional BCUs be incremented sequentially. For the location of the
BCU logic board DIP switch, see Figure 69.
In the PC, the device ID is set up as part of site configuration. If ARCNET
is used, always set the ARCNET address to match the device ID (see
Table 29 on page 151).
Figure 69. BCU (BMTW) Device ID: DIP Switch Location
SET UP TOOL
4 AMP MAX
ON OFF
S2
ON
ONLY
BCU I/O module
cable
Optional BCU I/O
module
Seven-segment
LED display
Option card
slots
BMTW-SVN01F-EN