Quick Start Guide - Tecsun PL-310 Operation Manuals

QUICK START GUIDE

TIME SETTING
1. Long press [TIME] button until "hour" is flashing in the display. Rotate the [TUNING]
knob to adjust the correct "hour".
2. Short press [TIME] button again, rotate the [TUNING] knob to adjust "minute".
3. Press the [TIME] button again to confirm your time setting.
ALARM SETTING
1. Long press [ALARM] button. Rotate the [TUNING] knob when "hour" is flashing in the
display.
2. Short press [ALARM] button again, the "minute" flashing. Rotate the [TUNING] knob to
adjust the "minute".
3. Short press [ALARM] button again to select 1 ~ 90 minutes of the Alarm's duration.
4. Finally, short press [ALARM] button again to confirm.
Note:
In ALARM section, [
buzzer, or if the display corner remains blank, which means the alarm is off.
LISTEN TO THE RADIO
1. Short press [POWER] button to turn on your radio.
2. Select FM by pressing the [FM] button, MW and LW by pressing the [MW/LW] button,
SW by pressing the [
desired meter band (meter band number flashes in the upper right corner of the
display) .
3. Turn the TUNING knob to your desired radio station.
4. You can also direct key-in the frequency numbers by pressing the numeric keys.
5. Adjust the volume level by turning the VOLUME knob up & down.
Note:
Be sure to fully extend the telescopic antenna when listening to SW and FM.
ATS (Auto Tuning Storage) on FM, MW, LW or SW band
1. Turn on the radio, and fully extend the antenna.
2. Short press [FM] button to Select FM band.
3. Long press on [FM] button until frequency number is running on the display. All the
available stations will be stored in the memory automatically. It will stop when it is done.
4. Then use the [TUNING] knob to tune around for those stored stations.
MW, LW or SW ATS is same as the FM ATS.
Special note: There are mode A & mode B during applying ATS in SW.
Mode A : Auto-searching & storing all the radio stations within all meter bands.
Mode B: Auto-searching & storing all the radio stations within present meter band.
] means ALARM is set to radio-on; [
] or [ ] button sequentially until you have selected the
] means ALARM is set to