Cisco Nexus 3548 Command Reference Manual page 59

System Management Commands
enable (Call Home)
To enable the Cisco Smart Call Home service after you have configured the contact information, use the
enable command. To disable the Smart Call Home service, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled
Command Modes Callhome configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines You must configure an e-mail server. Your switch must have IP connectivity to an e-mail server. You
must configure the contact name (SNMP server contact), phone, and street address information before
you enable Call Home.
Examples
This example shows how to enable the Cisco Smart Call Home service:
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# enable
contact email address is not configured
callhome can not be enabled on the switch, because necessary configuration has not been
done
Please check if all of following configuration is done
contact person name(sysContact)
contact person's email
contact person's phone number
street addr
To configure sysContact, please use snmp-server command
switch(config-callhome)#
This example shows how to disable the Cisco Smart Call Home service:
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# no enable
switch(config-callhome)#
OL-27851-02
enable
no enable
Modification
This command was introduced.
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
enable (Call Home)
49