S6Trk Card; M 4 Dli Card - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL

3.11 S6TRK CARD

There are no options to select on this card. Insert the S6TRK card into any universal
slot in the KSU or expansion cabinet
card ejectors on each card to ensure that it is fully inserted into the back plane
connector.
3.12 2 E&M 4 DLI CARD
This is the same card as used on the DCS Compact. The E&M trunk circuits on this
card can be set to provide either Type 1 or type 5 operation. Type 1 operation is used
when connecting to Telco circuits and type 5 is used when connecting "back to back"
across a private cable. Set the jumpers located between the two relays
9) according to the table below. Both of the jumpers for each circuit must be set to the
same type for correct operation.
CIRCUIT
1
1
1
1
2
2
2
2
WARNING: Turn the system off and remove the card from the system before
attempting to change jumper settings. 48 volts is present on the jumpers at all times
the system is turned on.
NOTE: When set to TYPE 1 the E&M Tie line circuits on this card are USOC TYPE
TL11M.
Insert the 2 E&M X 4 DLI card into any universal slot in the KSU or expansion cabinet
(see Figure 3–1). Push firmly in the middle of both card ejectors on each card to ensure
that it is fully inserted into the back plane connector
(Figure 3–8)
(see Figure 3–1). Push firmly in the middle of both
(Figure 3–9)
JUMPER POSITION
J1
J1
J2
J2
J3
J3
J4
J4
3.3
INSTALLATION
PART 3 JUNE 2002
(see Figure 3–
TYPE
T1 TYPE 1
T5 TYPE 5
T1 TYPE 1
T5 TYPE 5
T1 TYPE 1
T5 TYPE 5
T1 TYPE 1
T5 TYPE 5
HOME
PAGE
Table of
Contents