Samsung iDCS 100 Installation Section page 113

HOME
PAGE
iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 12 JUNE 2002
Table of
Contents
Power Supply. When you have done this then check the MEM3 or MEM4 card and
ensure that the memory switch is in the ON position. Next turn the KSU off and remove
the SVMi-8 card by gently pulling on the card. Lay the SVMi-8 card face up on a non-
conductive surface.
Position the second VPM over the card connector on the SVMi-8 base board and gently
apply pressure until the card seats. The SVMi-8 card can now be reinstalled in the KSU.
12.2