Ricoh 3590DNP Operating Instructions Manual page 169

❖ No.of ldling Rotations: Quality Start
When you use the Quality Start
mode, you can select how many
times the drum unit idles.
Note
❒ Default: 7 times
❖ Deflector Angle
You can change the angle of the
wing guide depending on the pa-
per type you use.
• Up (Select this setting when
standard thickness or thin pa-
per misfeeds at the paper exit
section occur frequently.)
• Down (Select this setting when
1
A4 – B5 JIS, 8
per is not delivered properly to
the paper delivery tray.)
Note
❒ Default: Auto
❖ Auto Class
Instead of using the Separate
mode, you can make the following
settings:
• Start Automatically (After the
last page of each printing set is
fed out to the paper delivery
tray, the machine stops for a few
seconds. Then, the next cycle
begins.)
• Stop (After the last page of each
printing set is fed out to the pa-
per delivery tray, the machine
stops. If you press the {Start}
key, the next cycle begins.)
Note
❒ Default: Stop
" × 11" thick pa-
/
2
Settings You Can Change with User Tools
❖ Master/Ink Remaining Volume
Specifies whether you can check
the amount of ink and master.
• [Off] (You cannot check the re-
maining amount of ink or mas-
ter.)
• [On (Below half)] (When the re-
maining amount of ink or mas-
ter is less than half, the display
panel indicates these amounts
when you turn on the main
switch.)
Note
❒ Default: Off
❖ Paper Type
You can select the paper type.
Note
❒ Default: Standard
❖ Paper Type: User1–2
You can register a frequently used
paper type and have it shown on
the paper type menu as [User 1] or
[User 2].
Note
❒ Default: Standard: No Feed
A
Select the paper type.
• Standard: "No feed" "Dou-
ble feed"
• Thick Paper: "No feed" "Dou-
ble feed" "Medium"
B
Press [OK].
5
157