Lower Mount Tube Installation; Upper Frame Assembly Installation; Top Assembly To Upper Frame Assembly Installation; Inlet Installation - Cub Cadet 59A30045150 Operator's Manual

2-7 Lower Mount Tube Installation

Secure the (2) lower mount tubes P#(B0640) to the rear
frame bracket using (2) 5/16"-15 u-bolts P#(K1098) and
(4) 5/16"-18 nylon flange locknuts P#(K2516) PER
TUBE. Refer to Figure 2-7.
Figure 2-7
Lower Mount
Tubes
(2) 5/16"-18
U-Bolts
PER BRACKET
2-8 Upper Frame Assembly
Installation
Lift the upper frame assembly P#(A1114) into position,
and slide onto the lower mount tubes as shown in Figure
2-9 and secure with (2) 1/2" x 2-1/4" clevis pins
P#(K0133) and (2) Rue Ring cotter pin clips P#(K1437).
Note: It is recommended that someone assist you when
installing the upper frame assembly.
2-9 Top Assembly To Upper Frame
Assembly Installation
Position the top assembly P#(A1148) above the upper
frame assembly as shown in Figure 2-9. Fasten the top
assembly to the upper frame assembly using (2) 5/16"-
18 x 2-1/2" HHCS P#(K0125), (2) 1/4" flat washers
P#(K0037), and (2) 5/16"-18 nylon flange locknuts
P#(K2516). Leave the locknuts slightly loose, to allow
the top assembly to open and close easily. Refer to
Figure 2-10 for hardware location.
Figure 2-9
Rue Ring
Cotter Pin
Top Assembly
(4) 5/16"-18
Locknuts
PER
BRACKET
Inlet

2-10 Inlet Installation

Insert the Inlet P#(V0019) into the hole on the top
assembly from the inside and then snap the inlet into
place. The inlet should pivot freely about the hole.
Rear Frame
2-11 Hinge Kit Assembly Installation
Bracket
Assemble the hinge kit as shown in Figure 2-11, using
(2) 5/16"-18 x 1" HHCS P#(K1154), (3) 5/16"-18 nylon
flange locknuts P#(K2516), (5) 1/4" flat washers
P#(K0037) and (2) swing arm brackets P#(ZT-0004).
Place (1) vinyl cap P#(J0289) on the end of the hex bolts
as shown in Figure 2-11. Leave the nuts loose enough to
allow fluid movement of the top when opening and
closing. When opened, the top should rest on the middle
joint of the hinge allowing it to remain up.
Figure 2-11
10
Clevis
Pin
Clip
(2) 5/16"-18 x 2-1/2" HHCS
(2) 1/4" Flat Washers
(2) 5/16"-18 Locknuts
K1154
K2516
J0289
ZT-0004
Nylon
Flange
Locknut
Hex
Flat
Bolt
Washer
K0037