Weight Kit Installation - Cub Cadet 59A30045150 Operator's Manual

2-19 Weight Kit Installation

Note:
Installing a weight kit is mandatory for safe operation of the collection system.
—
When installing the weight bar, you should have another person to help position the weight.
—
If removing PTO assembly for side-discharge mowing, please also remove the weight kit.
—
Installation:
To install left mount plate (A) perform the following;
Remove (1) existing torx screw (B) from front left side of mower. Retain screw for later use.
—
Remove (1) existing hex bolt from bottom left side of mower.
—
Align left mount plate (A) to holes in mower where hardware removed.
—
Fasten left mount plate (A) to front left side of mower using (1) torx screw, removed previously.
—
Fasten left mount plate (A) to bottom left side of mower using (1) 3/8" flat washer (D) P#(K0047) &
—
(1) 3/8"-16 x 1-1/4" hex bolt (E) P#(K1192).
Repeat process to install right mount plate (C).
Position weight bar (F) onto left & right mount plates and fasten using (1) 1/2"-13 u-bolt (G) and (2) 1/2"-13 flanged
lock nuts (H) per side.
Refer to Figure 2-20a, 2-20b & 2-20c.
Figure 2-20a
Figure 2-20b
C
H
F
E
15
!
A
B
To Prevent Serious Injury-
Weight Kit Must Be Installed
At All Times While Grass
Collection System Is In Use.
D
G
Figure 2-20c
WARNING