Page 1
(Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your Cub Cadet dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
Page 2
From the operator’s position, locate the model plate in the front, left portion of the plastic grass catcher cover. This information will be necessary to use the manufacturer’s web site and/or seek help from Dealer Referral Line or a Cub Cadet dealer. CUB CADET LLC P.
Page 3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4
26. Use only accessories and attachments approved for this dump cart, lawn roller, etc.) on slopes greater than 5 machine by the machine manufacturer. Read, degrees. When going down hill, the extra weight tends to understand and follow all instructions provided with the push the tractor and may cause you to loose control.
Page 5
NOTE: Model 190 Triple Bagger Kit is designed for use on Cub Cadet Fast Attach™ compatible tractors equipped with 50-inch cutting deck only.This will NOT mount, nor operate safely or properly on any other tractor regardless of...
Page 6
SECTION 2: LOOSE PARTS The grass catcher kit is shipped with following loose parts in the carton. Please remove all loose parts, including the hardware pack, from the carton before discarding it. Compare with Figure 1 to check that all parts were included. Note that the kit and the hardware pack contain extra items which are not used on your unit.
Page 7
SECTION 3: ASSEMBLY & OPERATION NOTE: References to left, right , front and rear of the tractor are from the operator’s position, unless otherwise stated. • Before assembly, place the tractor on a firm, level surface, disengage the PTO, stop the tractor engine and set the parking brake.
Page 8
• Remove the cutting deck from beneath the tractor NOTE: An extra set of carriage bolt and lock nut have (refer to instructions for Deck Removal in your tractor’s been supplied in your accessory kit. You may replace operator’s manual), then gently flip the deck over to the old hardware for the chute stop bracket with these expose its underside.
Page 9
• Insert the lower end of the chute tube over the discharge chute so that its two notches fit into the Insert chute tube here two corresponding notches on the discharge chute. See Figure 9. • Secure by placing the ends of the two short retainer straps on the discharge chute over the pins on the chute tube.
Page 10
SECTION 4: PARTS LIST FOR MODELS 190-190-100 & 190-192-190 17 11 16 25 See parts 29 13 break-down below Components of Cover Assembly pn # 664-04018: Components of Bag Assembly:...
Page 11
Model 190-190-100 & 190-192-190 Ref. Part No. Description Ref. Part No. Description 17200A Catcher Support Bracket 742-04067 Blade : High Lift; Cub Cadet 17247 Tubing Adapter 777D03361 Logo: Cub Cadet 631-0221 Chute Elbow 783-0601 Catcher Support Bracket 783-0673 Catcher Support Bracket RH 664-04018 Cover Assembly (includes ref.
Page 12
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Cub Cadet possesions and territories, except those sold through LLC with respect to new merchandise purchased and used in Cub Cadet’s authorized channels of export the United States, its possessions and territories.