Assembly & Installation - Cub Cadet 19A40002100 Operator's Manual

Assembly & Installation
NOTE: References to left, right, front and rear of the tractor are
from the operator's position, unless otherwise stated.
• Before assembly, place the tractor on a firm, level surface,
disengage the PTO, stop the tractor engine and set the
parking brake.
• For convenience, pivot the seat forward and leave it in
that position until the grass collector is fully mounted and
assembled.
Assemble Mounting Brackets
To assemble the bagger mounting assembly, locate the
mounting assembly pack and follow these steps:
1. Attach the two hitch side brackets to the universal rear
attachment bracket using four hex bolts and flange lock
nuts. With the hooks on the hitch side brackets pointing
down, the tabs on the hitch plates should be pointing
upwards. See Fig. 4-1.
2. Flip over assembly and mount the hitch support bracket to
the mounting assembly using the hardware found in pack
689-00087. See Fig. 4-2.
Note: It might be easier during the mounting stage to
leave this hardware only finger tight to facilitate lining up
the hitch hole for the clevis pin. You will be instructed to
tighten this hardware later in this manual.
8
Figure 4-1
Side View
Figure 4-2
Assembling The Support Assembly
Locate the upright support bracket and the bag support
assembly. Assemble it by following these steps:
1. Lay the bag support assembly topside down with the
mounting bracket portion facing upwards.
2. Insert the notched end of the vertical support bracket into the
bag support assembly, as in Fig. 4-3, and secure with a 5/16-18
carriage bolt and 5/16-18 flange lock nut. See Fig. 4-4.
Figure 4-3
3