Advertisement
5
EN
Sewing on buttons
Move the drop feed control to right side to
lower the feed dogs. (1)
Change presser foot to button sewing foot.
Turn the stitch length dial to "0".
Position the work under the foot. Place the
button in the desired position, lower the
foot. Set the pattern selector knob on zigzag
stitch. Adjust the stitch width between "3" - "5"
according to the distance between the two
holes of the button. Turn the handwheel to
check that the needle goes cleanly into the
left and right holes of the button. Set the
pattern selector knob on straight stitch, and
sew a few securing stitches. Set the pattern
selector knob on zigzag stitch, and slowly
sew on the button with about 10 stitches. Set
the pattern selector knob on straight stitch,
and sew a few securing stitches.
If a shank is required, place a darning
needle on top of the button and sew. (3) For
buttons with 4 holes, sew through the front
WZR KROHV ¿UVW SXVK ZRUN IRUZDUG DQG
then sew through the back two holes(3).
Move the drop feed control to left side for
normal use.
Advertisement
