Install The Sorter Wheel; Step 1: Unlock The Wiper Arm; Step 2: Rotate The Wiper Arm Up - Ioline CrystalPress User Manual

Install the Sorter Wheel

Rhinestones and crystals are prepared for delivery to the Transfer
Sheet by the Sorter Bowl(s). Each size of crystal (6ss to 30ss) requires
a separate Sorter Wheel that has alignment pits designed to fit the
element. In some cases, different brands also require special Sorter
Wheels. The customer service specialists at Ioline will assist custom-
ers with choosing the correct Sorter Wheels for brands and sizes of
supported crystals. Sizes are listed in the Optional Equipment section
later in this chapter.
Turn ON machine power then use the following steps to install a
Sorter Wheel in the Sorter Bowl. Removing a Sorter Wheel is covered
later in the Operation chapter.

Step 1: Unlock the Wiper Arm

Rotate the Wiper Arm Clamp clockwise to unlock the wiper assembly.
Figure 12.

Step 2: Rotate the Wiper Arm Up

Rotate the Wiper Arm assembly all the way up away from the Sorter
Bowl.
Figure 13.
Unlock the Wiper Arm.
Rotate Wiper Arm.
Operation
i
Note
It is recommended that Sort
Wheels are installed with machine
power turned ON because the
locating pin is held in place when
the motor has power. It is pos-
sible to install the wheel with
power off but it will likely take
longer.
15