Install The Sort Wheel(S); Assemble And Install The C-Stick Tool; Insert A Transfer Sheet; Connect The Power Cord - Ioline CrystalPress User Manual

12 Ioline CrystalPress User Guide
Caution
Ioline recommends using
a surge protector power
strip for both the machine
and the computer.
Caution
Keep hands and loose
clothing away from all
moving parts of the
machine.
i
Note
The CrystalPress will al-
ways perform the initialization
sequence at power ON. The ini-
tialization sequence will not start
unless the Wiper Arm Clamps are
completely locked closed.

Install the Sort Wheel(s)

Install the sort wheels in the Sorter Bowls if they do not come pre-
installed. This process is outlined in the CrystalPress Quick Start Guide
and also in the Operation chapter. Some machine configurations
require more than one sort wheel.

Assemble and Install the C-Stick Tool

Follow the directions in the CrystalPress Quick Start Guide and or in
the Operation chapter to assemble and install the C-Stick tool in the
Carriage.
Figure 5. The

Insert a Transfer Sheet

Follow the directions in the CrystalPress Quick Start Guide and or
in the Operation chapter to insert a Transfer Sheet between the Pinch
Wheels and the Drive Shaft. Make sure to lower the Pinch Wheel Lever
to lock the sheet in place before proceeding.

Connect the Power Cord

Find the power switch on the bottom of the back of the right End
Cover. Make sure the switch is in the OFF 'O' position. Connect the
power cord to the machine and then to a power outlet.

Connect the Machine to the Computer

With machine power off, connect the CrystalPress to your computer
with the provided USB cable. Before powering on the machine, make
sure the software is installed so that the correct drivers are available.
See the Operation chapter if a serial port connection is required.

Power On

With the computer already powered on, turn the CrystalPress power
switch to ON 'I'. The Carriage will initialize itself by moving right un-
til it touches the right end plate then moving left until it touches the
left end plate. It will travel back to the right end plate and stop, then
the sort wheels will turn then stop when initialization is complete.
The CrystalPress machine is ready to use as soon as the green Status
light on the Keypad is visible.

Start CrystalStudio

With the Status light showing green, start the CrystalStudio soft-
ware. It will automatically connect to the CrystalPress if the setup
process was successful.
Continue to the Operation chapter for details on using the
CrystalPress and making a motif.
C-Stick pick-and-place tool.