ResMed escape s8 User Manual page 19

H
OW TO EXIT OUT OF A MENU
Press the Right key (Exit). This will take you back to the Patient Menu screen.
H
OW TO EXIT OUT OF AN ITEM WITHIN THE MENU
Press the Right key (Exit).
H C
OW TO HANGE THE
During ramp time, the pressure increases from a low pressure to the prescribed
treatment pressure. You can set the ramp time in 5-minute intervals, from 0 minutes
(OFF) up to a maximum ramp time set by your clinician.
The standby screen displays the current ramp time in the right-hand corner. To change
the ramp time, press the Up or Down key until the desired ramp time appears.
Once a ramp time is selected, begin therapy by pressing the Start/Stop key.
When ramping begins the LCD will display the word "RAMPING", with the current
pressure indicated as dashes. Each dash is approximately equivalent to 2 cm H
example, six dashes represents approximately 12 cm H
H
OW TO CHANGE THE
If you move or travel with your
to adjust the altitude compensation setting. Changes in altitude will affect the pressure
S8 E
delivered by the
You can use the Altitude setting (ALT) to specify the altitude range at which you are
using your S8 E
SCAPE
standby (RAMP) screen. Scroll to ALT and select Change (Left key). Press the Up or
Down keys until you see the setting option that you require.
There are four altitude settings to choose from:
0–2000ft (0–609 m)
•
2001–4000ft (610–1219 m)
•
4001–6000ft (1220–1828 m)
•
6001–8500ft (1829–2591 m).
•
For example, if you are at an altitude of 3107' (947 m), your altitude compensation
setting would be 2001–4000ft (610–1219 m), as 3107' (947 m) falls within that range.
Press the Left key (Apply) to select the correct setting.
H
OW TO CHANGE THE LANGUAGE SETTING
To display menus and messages in a different language, select the
pressing the Left key in the standby (Ramp) screen. Scroll to LANG and select Change
(Left key). Press the Up or Down keys until you see the language that you require.
O
THER VIEWABLE INFORMATION
You can also view the total number of hours of treatment (USED HRS); the number
of sessions that the
software version installed on your unit (SW). Access to all of these screens is provided
via the menu. See "How to enter the menu screens" on page 16.
R T
AMP IME
A
LTITUDE SETTING
S8 E
SCAPE
.
SCAPE
. Select the S8 E
SCAPE
S8 E
was used in a usage period (USAGE); and the current
SCAPE
O pressure.
2
to areas of different altitude, you will need
menu by pressing the Left key in the
H
OW TO USE THE
O. For
2
S8 E menu by
SCAPE
K
EYPAD
17