Icom IC-R30 Advanced Manual page 96

6
MENU SCREEN
■ Function (Continued)
Monitor
[MENU] > Function > Monitor
Select an option for the [SQL] Monitor function. (BASIC MANUAL Section 3)
• Push: Hold down [SQL] to monitor the frequency. Release to stop
monitoring.
• Hold: Push [SQL] momentarily to monitor the frequency and push
momentarily again to cancel it.
Dial Speed-UP
[MENU] > Function > Dial Speed-UP
Turn the Dial Speed Acceleration ON or OFF. The acceleration automatically speeds up
the tuning dial speed when you rapidly rotate [DIAL].
• OFF: Turns OFF the function.
• ON: Turns ON the function.
Key Lock
[MENU] > Function > Key Lock
Select the key lock type when the Key Lock function is ON.
• Normal: All keys and dials except [SQL] and [VOL] are locked.
• No SQL: All keys and dials except [SQL] is locked.
• No VOL: All keys and dials except [VOL] is locked.
• ALL: All keys and dials are locked.
Active Band
[MENU] > Function > Active Band
Enables continuous frequency selection of the receive frequency across all bands using
[DIAL].
L This setting does not affect the scan.
• Single: When you change the frequency on the band edge, the top or bottom
frequency in the displayed band is selected.
• ALL: When you change the frequency, the next band is displayed.
Set the selectable frequencies on the receiver to all bands for
continuous selection.
Bar Antenna
[MENU] > Function > Bar Antenna
Select whether or not to use the internal bar antenna to receive the AM broadcast band
(0.495 ~ 1.620 MHz).
L The Attenuator does not work, when using the bar antenna
• Not used: Does not use the internal bar antenna.
• Use: Uses the internal bar antenna. (The bar antenna is used for only the
AM broadcast band.)
(BASIC MANUAL Section 3).
6-19
(Default: Push)
(Default: ON)
(Default: Normal)
(Default: All)
(Default: Use)