BSR 2000 Configuration and Management Guide
Displaying the EVT Configuration
Use the following commands to display EVT configuration information:
Displaying EVT Counts
The show evt command displays EVT counts for all groups, on a specified group, or
specified events, as shown below:
MOT (config)# show evt [<slot:group>] [<range>]]
Clearing EVT Counts
EVT counts can be cleared for all groups, for a specified group, or specified events:
MOT (config)# clear evt [<slot:group>] [<range>]]
Disabling EVT Logging
The following command options disable EVT logging:
3-28
removes all previous logging evt set configurations.
MOT (config)# no logging evt
removes all previous logging evt set and logging evt clear configurations.
MOT (config)# show logging evt
This command displays the EVT configuration entries in the running
configuration file.
MOT (config)# show logging reporting
This command displays the recording mechanism for logging messages based on
their severity level. The display output is in the format: logging reporting
<severity> <logging location> e.g. "logging reporting alert local".
MOT (config)# logging evt clear [l|t|s|c] [<slot:group>] [<range>]
This command disables EVT logging for the specific logging destination(s). For
example, it may be useful to turn off console logging for a warning severity
message which is originally sent to the local console.
MOT (config)# logging evt clear
This command disables logging of all EVTs and can be used to stop a flood of
EVT log messages from going to the console.
MGBI
Release 1.0
526360-001-00 Rev. B