Working On The Engine Without Removing The Engine; Removal Of The Air Pump; Removal Of The Cylinder / Piston - PEUGEOT Jet C-Tech Workshop Manual

WORKING ON THE ENGINE WITHOUT REMOVING THE ENGINE

WORKING ON THE ENGINE WITHOUT REMOVING THE ENGINE

Removal of the air pump.

- Remove the rear mudguard.
- Remove the 4 screws (1) that secure the air
pump (2).
- Disconnect the 2 air hoses (3).
- Note: When re-installing, install the air pump
with its 2 guiding bushes and a new O-ring
slightly lubricated.

Removal of the cylinder / piston.

- Remove the storage compartment (see
procedure 4).
- Remove the footboard and the left tunnel (see
procedure 3).
- Remove the bottom panel.
- Disconnect the lower pump from the coolant
pump to drain the cooling system.
- Disconnect the coolant pipes from the cylinder
head and cylinder.
- Disconnect the temperature sensor.
- Disconnect the suppressor.
- Remove the spark plug.
- Remove the exhaust.
- Loosen the attachment screw (1).
- Slacken off the cylinder head/cylinder
4 mounting bolts in the order shown, in 2 or 3
stages.
- Remove the 5 bolts.
- Remove the cylinder head and its gasket.
- Remove the cylinder and its bottom seal.
22
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
1
A
C
3
1
D
B