Figure 7-1 Chassis Removal; Table 7-13 How To Remove The Chassis - Honeywell UDC3300 Product Manual

7.8 Parts Replacement Procedures,
How to remove the
chassis
84
Refer to Figure 7-1 for steps and follow the procedure listed in Table 7-13.
Table 7-13 How to Remove the Chassis
Step
1 Loosen the screw on the front face.
2 Insert a flat-bladed screwdriver into the hole on the top of the case as shown
in Figure 7-1 and pry chassis forward slightly until the chassis connectors
separate from the back of the case.
3 Grasp the bezel and pull the chassis out of the case.
Figure 7-1 Chassis Removal
UDC3300 Limit Controller Product Manual
Continued
Action
Insert screwdriver
2
and pry forward
22637
3
Grasp bezel
and pull
chassis out
1
Loosen screw
Continued on next page
1/01