Installing The Component Rails - HP StorageWorks Reference Manual

Installing the component rails

Component rails are the inner portion of the rack rail system that attached to the
tape enclosure.
1. Align the slotted holes on the left and right component rails with the three
2. Slide the component rails toward the rear of the enclosure 2 until they lock
Figure 6: Attaching the component rails to the enclosure
Note:
the rail and slide it forward
1U Rackmount Tape Enclosure Reference Guide
It is important to install rack components level. To ensure that the 1U
Caution:
tape enclosure is installed correctly it may be necessary to measure the height
of the correct mounting holes in the front and rear vertical mounting bars.
pins on the sides of the enclosure 1. See
into place.
4
3
To remove the component rail, pull out the spring-loaded tab
Caution: If you are returning the 1U Rackmount Tape Enclosure for service, be
sure to remove and save the component rails.
Figure
1
.
4
Rack Installation
6.
2
15118
on the side of
3
17