Tools Required; Installing The Tape Enclosure In A Rack; Before You Begin - HP StorageWorks Reference Manual

Rack Installation

Tools required

If you are installing the tape enclosure in a rack with unmarked holes in the
vertical mounting bars the following items will make the rack installation easier:
If you are installing the tape enclosure in a rack with threaded holes in the vertical
mounting bars you will need the following tool:

Installing the tape enclosure in a rack

When installing the enclosure in a rack:

Before you begin

If you are installing the tape enclosure in a rack with unmarked holes in the
vertical mounting bars, identify and mark the correct mounting holes in the rack
before you begin rail installation.
16
Pencil
Tape measure
3/16" (5mm) flat-blade screwdriver
WARNING: To reduce the risk of personal injury or equipment damage, be
sure that:
The rack leveling jacks are extended to the floor
The full weight of the rack rests on the leveling jacks
The stabilizing feet are attached to the rack if it is a single rack installation
The racks are coupled in multiple rack installations
Only one component is extended at a time. A rack may become unstable if
more than one component is extended for any reason.
Start at the bottom of the rack, or at the top of a previously mounted
component, and work upward.
If possible, install the heaviest components at the bottom and lighter ones
toward the top of the rack.
Make sure that the rack-mounting rails are level from front to back.
1U Rackmount Tape Enclosure Reference Guide