Measuring With The Rack Template; Installing The Rack Rails - HP Xw460c - ProLiant - Blade Workstation Setup And Installation Manual

To install an enclosure into the rack:
Disassemble the enclosure
1.
Use the rack template
2.
rack rails.
Install the rack rails
3.
Install the enclosure into the rack
4.

Measuring with the rack template

The rack template ships with the rack rail kit and provides detailed instructions on where to position the
enclosure rack rails and where to install the four cage or clip nuts. Each enclosure kit includes the rack
rails recommended for that enclosure.
NOTE:
used in racks with square holes. Clip nuts should be used in racks with round holes.
When installing multiple enclosures, install the rack rails and cage or clip nuts for one enclosure, and then
install the enclosure. Repeat for each additional enclosure.

Installing the rack rails

The rack rails are marked for easy identification. The left rack rail is marked "L" and the right rack rail is
marked "R."
To install the rack rails:
Begin with the left rack rail. Align the end of the rail with the rear rack column.
1.
Slide the rack rail closed until the end of the rail is locked in place, wrapping behind the rear rack
2.
column.
("Disassembling the
("Measuring with the rack
("Installing the rack
("Installing the enclosure into the
Four cage nuts and four clip nuts are included with the enclosure. Cage nuts should be
enclosure" on page 22).
template" on page 26) to mark the locations for the
rails" on page 26) for each enclosure.
rack" on page 27).
Installation 26