HP StorageWorks Reference Manual page 23

Note:
one or two SCSI buses in the enclosure.
6. Plug the external SCSI cable from the SCSI controller to the appropriate
Note:
7. Plug the AC power cord into the power cord connector, then into a grounded
Figure 13: Connecting the power and SCSI cables to the tape enclosure
8. Install the cable support clip(s) at the back of the rack rail(s) on one or both
1U Rackmount Tape Enclosure Reference Guide
Refer to"Internal cable
connector(s) on the rear panel of the enclosure. See
Daisy-chaining of two or more 1U Rackmount Tape Enclosures is not supported.
outlet. See Figure 13.
sides of the enclosure. See
configurations" on page 33 for details on configuring
Figure 14.
Rack Installation
Figure 13.
15129
23