HP StorageWorks Reference Manual page 38

Tape Drive Installation and Replacement
9. Install the left and right mounting brackets to the sides of the new tape drive
Figure 28: Installing the drive mounting brackets
10. If you are not using the remote SCSI ID switch on the tape enclosure, set the
11. If you are using the remote SCSI ID switch on the tape enclosure, remove all
12. Position the keyhole slots in the left and right mounting brackets over the
38
using the screws removed in
SCSI ID with jumpers on the back of the new drive. Refer to the
documentation for your tape drive for information about setting the SCSI ID.
the jumpers from the back of the new drive. The switch will connect to the
pins normally programmed by the jumpers.
Caution: To prevent possible damage to the tape enclosure or to cause the
rack to become unstable, you must provide support under the enclosure when
installing a drive.
mounting posts attached to the enclosure. While supporting the enclosure
from the bottom press down 1 so that the drive is flat against the bottom of
the enclosure. See Figure
enclosure until the spring-loaded pin snaps into place 3, locking the drive into
the enclosure.
step 8. See Figure
29. Slide the drive 2 toward the back of the
1U Rackmount Tape Enclosure Reference Guide
28.
15127