HP StorageWorks Reference Manual page 30

Tape Drive Installation and Replacement
12. Attach the power cable 1, SCSI ID cable 2 (if used), and SCSI data cable 3
Figure 20: Attach cables to the drive
Note:
enclosure.
30
To prevent possible data errors, when there is only one drive on a
Caution:
SCSI bus that drive must be connected to the SCSI port closest to the terminator.
to the back of the drive. Refer to
on page 33 to identify the SCSI cable for your configuration.
Fold excess SCSI cable length and secure with the clips provided in the tape
WARNING: To avoid possible injury from rotating fan blades do not attempt
to operate the tape enclosure with the top cover removed.
Caution: When reinstalling the top cover, be sure the latch is fully engaged
and is flush with the cover to avoid interference with devices installed above
the tape enclosure.
Figure 20 and "Internal cable
3
15109
1U Rackmount Tape Enclosure Reference Guide
configurations"
1
2