Configuring Ipv6 Pim-Ssm; Ipv6 Pim-Ssm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Sm - HP MSR2003 Configuration Manual

NOTE:
Generally, a BSR performs BSM semantic fragmentation according to the MTU of its BSR interface. For
BSMs originated due to learning of a new IPv6 PIM neighbor, semantic fragmentation is performed
according to the MTU of the interface that sends the BSMs.

Configuring IPv6 PIM-SSM

IPv6 PIM-SSM requires MLDv2 support. Enable MLDv2 on IPv6 PIM routers that connect to multicast
receivers.

IPv6 PIM-SSM configuration task list

Task at a glance
(Required.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure IPv6 PIM-SSM, configure an IPv6 unicast IPv6 routing protocol so that all devices in
the domain are interoperable at the network layer.

Enabling IPv6 PIM-SM

The implementation of the IPv6 SSM model is based on subsets of IPv6 PIM-SM. Therefore, you must
enable IPv6 PIM-SM before configuring IPv6 PIM-SSM.
When you deploy an IPv6 PIM-SSM domain, enable IPv6 PIM-SM on non-border interfaces of the
routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Step
1. Enter system view.
2. Enable IP multicast routing,
and enter MRIB view.
3. Return to system view.
4. Enter interface view.
5. Enable IPv6 PIM-SM.
Enabling IPv6 PIM-SM
Configuring the IPv6 SSM group range
Configuring common IPv6 PIM features
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
quit
interface interface-type
interface-number
ipv6 pim sm
306
Remarks
N/A
By default, IPv6 multicast routing is
disabled.
N/A
N/A
By default, IPv6 PIM-SM is
disabled.