HP MSR2003 Configuration Manual page 126

Figure 43 Network diagram
Source
10.110.5.100/24
Table 7 Interface and IP address assignment
Device
Router A
Router A
Router B
Router B
Router C
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Configure OSPF on the routers in the PIM-DM domain to make sure the following conditions are
met: (Details not shown.)
The routers are interoperable at the network layer.
The routers can dynamically update their routing information.
3. Enable IP multicast routing, IGMP, and PIM-DM:
# On Router A, enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
GE2/1/1 GE2/1/3
Router D
PIM-DM
Interface IP address
GigabitEthernet
10.110.1.1/24
2/1/1
GigabitEthernet
192.168.1.1/24
2/1/2
GigabitEthernet
10.110.2.1/24
2/1/1
GigabitEthernet
192.168.2.1/24
2/1/2
GigabitEthernet
10.110.2.2/24
2/1/1
Router A
GE2/1/1
GE2/1/2 GE2/1/1
Router B
GE2/1/1
Router C
Device
Router C
Router D
Router D
Router D
Router D
116
Receiver
Host A
Host B
Receiver
Host C
Host D
Interface IP address
GigabitEthernet
192.168.3.1/24
2/1/2
GigabitEthernet
10.110.5.1/24
2/1/1
GigabitEthernet
192.168.1.2/24
2/1/2
GigabitEthernet
192.168.2.2/24
2/1/3
GigabitEthernet
192.168.3.2/24
2/1/4
Figure 43. (Details not