Table of Contents
Advertisement
17
When the water tank is empty, remove the water tank, rinse it and ll it
up to the MAX level with fresh water. Place it back into the machine.
18
Empty the container and place it back under the dispensing spout.
19
When the amount of water needed for the rinse cycle has been
completely dispensed, this icon on the side is displayed. Press the"
button to quit the descaling cycle.
20
The machine automatically primes the circuit.
21
The machine now carries out the warm-up and automatic rinse cycle to
prepare for product brewing.
22
Empty the drip tray and place it back.
23
Remove and empty the container.
24
The descaling cycle is now complete.
25
Place the "INTENZA+" (if installed) water lter back into the water tank
and insert the Automatic Milk Frother.
Note:
At the end of the descaling cycle, wash the brew group as described in the
"Weekly cleaning of the brew group" chapter.
The two rinse cycles are performed in order to have the circuit cleaned
with a pre-set amount of water and ensure proper machine operation.
If the water tank is not lled up to MAX level, the machine might require
three or more cycles.
ENGLISH
45
45
"
Advertisement
Table of Contents
