Advanced Display Module (Adm) Operation - Graco HFR Setup And Operation Manual

Advanced Display Module (ADM) Operation

Advanced Display Module (ADM) Operation
When main power is turned on by turning the main
power switch (MP) to the ON position, the splash screen
will be displayed until communication and initialization is
complete.
To begin using the ADM, the machine must be on and
enabled. To verify the machine is enabled, verify the
System Status Indicator Light (CB) is illuminated green,
. 5 on page 30. If the System Status Indicator
see F
IG
Light is not green, press the ADM Power On/Off (CA)
button . The System Status Indicator Light will illu
minate yellow if the machine is disabled.
If the machine is in the Disabled mode screen press
repeatedly to select a different operating mode.
Perform the following tasks to fully setup your system.
1. Set general system settings. See Advanced
Screen 1, page 80.
2. Set units of measure. See Advanced Screen 2,
page 80.
3. Enable/disable system features. See Advanced
Screen 3, page 81.
4. Define control mode, dispense mode, and pump
information. See System Screen 1, page 73.
5. Define dispense valve and other system settings.
See System Screen 2, page 73.
6. Define labels and other system settings. See Sys
tem Screen 3, page 75.
46
7. If L-Head is installed, define L-Head control
details. See Mix Head Operating Details Screen,
page 74.
8. Define level sensors and refill settings. See Supply
Screen, page 76.
9. Enable/disable temperature conditioning compo
nents. See Conditioning Screen 1, page 77.
10. Define temperature conditioning setpoints. See
Conditioning Screen 2, page 78.
11. If Night mode will be used, define Night mode set
tings. See Conditioning Screen 3, page 79.
12. Calibrate machine. See Calibration Screen, Main,
page 72.
13. Define shots. See Shots Screen, page 69.
14. Define sequences. See Sequences Screen,
page 71.
15. If desired, view/reset counters. See Maintenance
Screen, page 76.
313997ZAA