Advertisement
Caster Wheel Alignment
(See letter call–outs in Parts drawing on page 5.)
1 . Loosen bolt (D).
2 . Push line striper forward following a straight refer–
ence line.
Continuous Radius Striping
1 . Push line striper around radius.
2 . Stop.
Swivel Hub Bearing (G) Adjustment
1 . To swivel less freely, tighten nut (A).
Caster Wheel
(See letter call–outs in Parts drawing on page 5.)
1 . Once each year, tighten nut (A) until spring washer
bottoms out. Then back off the nut 1/2 to 3/4 turn.
2 . Once each year, tighten nut (B) until it begins to
compress spring washer. Then tighten the nut an
additional 1/4 turn.
Operation
3 . Stop.
4 . Tighten bolt (D).
3 . Tighten knob (E).
4 . Verify accuracy, then paint.
2 . To swivel more freely, loosen nut (A).
Operation
3 . Once each month, grease the wheel bearing (F).
4 . Check pin (C) for wear. If pin is worn out, therewill
be play in the caster wheel. Reverse or re–place
the pin as needed.
308943 3
Advertisement
