Install Upgrade Tokens - Graco HFR Setup And Operation Manual

Install Upgrade Tokens

NOTE: The Motor Control Module, Fluid Control Mod
ule, and Temperature Control Module connection to the
system is temporarily disabled during the installation of
upgrade tokens.
To install software upgrades:
1. Use correct software token stated in the table. See
Graco Control Architecture
manual for instructions.
NOTE: Upgrade all modules in the system to the
software version on the token, even if you are
replacing only one or two modules. Different soft
ware versions may not be compatible.
All data in the module (System Settings, USB Logs,
Recipes, Maintenance Counters) may be reset to
factory default settings. Download all settings and
user preferences to a USB before the upgrade, for
ease of restoring them following the upgrade.
See manuals for locations of specific GCA compo
nents.
The software version history for each system can be
viewed in the technical support section at
www.graco.com.
Token
16H821 HFR:
- Advanced Display Module
- Motor Control Module
- High Power Temperature Control Module
- Fluid Control Module (AC Power Pack)
- Discrete Gateway Module
- Communication Gateway Module
16G584 Tank Stand:
- Fluid Control Module
- Low Power Temperature Control Module
16G407 Ratio Monitoring (Flow Meters):
- Fluid Control Module
313997ZAA
™
Module Programming
Application
r_257396_3b9905_04b
ti12358a1
F . 15: Remove Access Cover
IG
Maintenance
ti12334a1
ti12354a1
55