Flushing - Graco HFR Setup And Operation Manual

Flushing

Flushing
Flush equipment only in a well-ventilated area. Do not
dispense flammable fluids. Do not turn on heaters
while flushing with flammable solvents.
• Flush out old fluid with new fluid, or flush out old
fluid with a compatible solvent before introducing
new fluid.
• Use the lowest possible pressure when flushing.
• All fluid components are compatible with common
solvents. Use only moisture-free solvents. See
Technical Data on page 108 for list of wetted com
ponents to verify compatibility of solvent with wetted
materials. See solvent manufacturers information
for material compatibility.
• To flush feed hoses, pumps, and heaters separately
from heated hoses, set PRESSURE RELIEF/DIS
PENSE valves (SA, SB) to PRESSURE
RELIEF/CIRCULATION
lines (N).
SA
N
• To flush entire system, circulate through gun fluid
manifold (with manifold removed from gun).
• To prevent moisture from reacting with isocyanate,
always leave the system dry or filled with a mois
ture-free plasticizer or oil. Do not use water. See
Important Two-Component Material Information
on page 20.
• Solvent pails used when flushing: follow your local
code. Use only metal pails, which are conductive,
placed on a grounded surface. Do not place pail on
a nonconductive surface, such as paper or card
board, which interrupts grounding continuity.
52
. Flush through bleed
SB
N
ti9880a1
• To maintain grounding continuity when flushing or
relieving pressure, hold a metal part of dispense
gun firmly to the side of a grounded metal pail, then
trigger gun.
313997ZAA