Operation; Machine Start-Up; Cutting Material - Graco GrindLazer 25M848 Operation, Parts

Operation

Machine Start-Up

1. If using a vacuum, attach vacuum hose to the
vacuum port. Turn the vacuum on.
2. Plug power cord into a grounded outlet.
3. Hold the unit with the cutters 2-4 inches (5-10 cm)
off the surface to be scarified.
4. Depress the trigger and adjust the speed dial to the
desired setting.
3A5575A

Cutting Material

1. While holding the machine firmly, press the cutters
into the surface to be cut.
2. When ready to stop cutting material, lift the cutters
off of the surface, release the trigger, and allow the
cutters to come to a stop.
3. Unplug the power cord from the power source.
Maintenance
1. Inspect the dust skirt on the scarifier daily. Repair or
replace the skirt if it is torn or damaged to ensure
maximum dust and debris containment.
2. Inspect cutters daily and replace cutters that appear
worn in order to achieve optimal cutting speed and
surface finish.
Operation
7