Transfer System Settings - Graco HFR Setup And Operation Manual

Transfer System Settings

NOTICE
Low-quality USB stick drives may lead to burning
out the USB port on the ADM. Use only high-quality
USB stick-drives with the ADM USB port.
Use the following process to transfer system settings
from one machine to another.
1. Insert a high-quality USB stick-drive into the USB
port on the system with the settings to be trans
ferred. Once the download is complete the SET
TINGS.TXT file will be located in the "DOWNLOAD"
folder.
NOTICE
The user should never attempt to modify the SET
TINGS.TXT file in any way. Graco is not responsi
ble for damages caused by an improperly modified
setup file.
2. Plug the USB stick-drive into a computer.
3. Navigate to the DOWNLOAD folder.
4. Copy the SETTINGS.TXT file from the DOWNLOAD
folder into the UPLOAD folder.
5. Remove the USB stick-drive from the computer and
install it into the ADM USB port for the second
machine. The software will automatically begin
updating.
313997ZAA
NOTE: Before the update begins the ADM automatically
shuts down the system, aborting any in-progress dis
pensing. When the software is updating the system a
pop-up box will appear to inform the user of the update
and the system will lock. Once the update is complete
the ADM will tell the user to cycle power to apply the
updates. Once this box appears it is safe to remove the
drive before cycling power.
6. When the software is done updating, remove the
USB stick-drive from the ADM USB port and install
in a computer.
7. Navigate to the UPLOAD folder and remove the
SETTINGS.TXT file.
NOTE: Immediately after uploading the settings,
remove the SETTINGS.TXT file from the UPLOAD
folder to prevent accidental loss of data the next time
the USB stick-drive is inserted into the ADM USB port. If
there is a SETTINGS.TXT file in the UPLOAD folder
when the USB stick-drive is inserted into the ADM USB
port the software will try to update the ADM.
Appendix F - USB Operation
105