Barco ACS-2048 User Manual page 32

4. Operation
Control Overview
`çåíêçä=lîÉêîáÉï
There are several ways to control the ACS-2048:
•
•
mçïÉêJré=fåáíá~äáò~íáçå
After connecting power to the ACS-2048, locate the power switch on the back of the
chassis, and turn the power ON. While the system is initializing, the following messages
are displayed:
Figure 4-1. System initialization message 1
Figure 4-2. System initialization message 2
Figure 4-3. System initialization message 3
32
The front panel is ideal for all basic system configurations. Available controls
include the Display Section and the buttons in the Inputs Section.
The ACS-2048 can also be controlled remotely via Ethernet. All system
commands are available. Typically, remote commands are used to switch inputs
from the Barco projector's "Communicator" touch screen, but more advanced
interfaces can be configured using the protocol. Refer to
for additional details.
A C S - 2 0 4 8
Ba rco
I n i t i a l i z i n g . . .
P r o g r a m L o a d i n g
ple ase wait...
T r a n s f e r r i n g t o
m a i n p r o g r a m . . .
Appendix B on page 93
ACS-2048 • User's Guide