Acs-2048 Rear Panel - Barco ACS-2048 User Manual

^`pJOMQU=oÉ~ê=m~åÉä
The figure below illustrates the ACS-2048 rear panel:
DVI OUT
B
1
Figure 2-1. ACS-2048 Rear Panel
1) DVI Outputs
2) Ethernet
Following are descriptions of each rear panel connector:
1)
2)
ACS-2048 • User's Guide
10/100 BASE-T
A
2
DVI Outputs
Two DVI-D connectors (A and B) are provided for the system's dual-channel
(Twin-Link) DVI output. These outputs provides a 10-bit or 12-bit (4:4:4 RGB)
signal as follows:
~
Connector A: 8 msb (most significant bit). Only 8-bit output mode can
be selected on this connector, providing standard 8-bit DVI output.
~
Connector B: 2 or 4 lsb (least significant bit), depending on the output
selection. To increase color depth, 10-bit or 12-bit output mode can be
selected on this connector. Use the Output Menu to change the output
mode and bit-width. In Chapter 4, refer to the
page 53 for details.
Please note:
~
In 10-bit or 12-bit mode, both outputs (A and B) must be connected to the
projector. In 8-bit mode, a connection is required from Connector A only.
~
HDCP encryption is provided on both connectors A and B.
~
Frame rates of 50Hz and 59.94Hz are supported.
In Appendix A, refer to the
details, and the "DVI-I Connector
Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the ACS-2048 system. The port is typically used for diagnostics or command-line
operations via Telnet (using port 23).
telnet 192.168.1.100 23
In Appendix A, refer to the
2. Hardware Orientation
3) AC Power
"Output Specifications" section on page 83 for
Pinouts" section on page 87 for pinouts.
"Ethernet Connector" section on page 88 for pinouts.

ACS-2048 Rear Panel

Model
ACS-2048
100 - 240 VAC
50 – 60 Hz, 1.0A
3
"Output Menu" section on
23