Unit Operation - Cornelius IDC PRO 255 Service Manual

IDC Pro 255 Service Manual
With a nylon bristle brush or
sponge, clean the inside of the ice
chute, gasket, and cover with
6
soap solution and rinse thor-
oughly to remove all traces of
detergent.
7 Re-assemble the ice chute assembly.
Using a mechanical spray bottle
filled with sanitizing solution, spray
8
the inside of the ice chute. Allow it
to air dry.
9 Close the display panel.
U O
NIT PERATION
!
WARNING:
This unit must be grounded to avoid possible electrical shock to the operator. The unit power cord is equipped with a
three pronged plug. If a three pronged (grounded) outlet is not available use an appropriate method to ground the
unit.
Failure to comply could result in serious injury, death or damage to the equipment.
To initially start up the unit for operation, perform the procedure in Table 21.
Step
1
2
3
Publication Number: 621058649SER
Table 20.
Table 21.
Connect electrical power to the unit.
Check for water leaks, and tighten any loose connections.
Dispense several drinks for checking.
Figure 64.
Figure 65.
Action
- 32 - © 2016, Cornelius Inc.