Comms Screen; Figure 48 - Comms Screen - York YK Series Operation Manuals

FORM 160.54-O1
ISSUE DATE: 9/10/2014

FIGURE 48 - COMMS SCREEN

OVERVIEW
(Screen shown from all applications equipped with Flash
Memory Card version C.MLM.01.05.xxx and later.
Screen layout from earlier versions slightly different.)
This screen allows definition of the necessary commu-
nications parameters. Refer to SECTION 4 - PRINTING
of this manual for details of the printer connections and
setup. Presently, there are no COM 2 communications
features available.
DISPLAY ONLY
None
For fields requiring access level of SER-
VICE. Service Technicians refer to the
OptiView Control Center - Service Instruc-
tions (Form 160.54-M1) for operation
instructions and explanation of all pro-
grammable setpoints and displayed values.
JOHNSON CONTROLS
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION

COMMS SCREEN

PROGRAMMABLE
Chiller ID
Access Level Required: OPERATOR
Define the numeric chiller ID when used within an ISN
network of chillers. This ID number is also printed at
the top of reports obtained with a local printer.
Printer Setup and COM 2 Setup
Access Level Required: OPERATOR
Pressing either key places a green selection box around
the first changeable parameter. Use the ▲ and ▼ keys
to place the selection box around the desired param-
eter to be changed. With the selection box around the
desired parameter, press the ENTER () key. A dialog
box is displayed permitting data entry. In VSD or LC-
SSS Modbus Protocol Configuration, COM2 button is
not shown because COM2 serial port is used for this
interface.
Printer Baud Rate
Define the baud rate at which the panel shall commu-
nicate to the printer.
00470VIP
145
2