Fig. 29 - Comms Screen - York YT Millennium Operating & Maintenance

OptiView Control Center
FIG. 29
OVERVIEW
(Screen shown from Flash Memory Card version
C.MLM.02.02.xxx and later. Screen layout from
earlier versions slightly different)
This screen allows definition of the necessary com-
munications parameters. Refer to PRINTER Section
of this book for details of the Printer connections and
setup. Presently, there are no COM 2 communications
features available.
DISPLAY ONLY
None
PROGRAMMABLE
Chiller ID
Access Level Required: OPERATOR
Define the numeric chiller ID when used within an ISN
network of chillers. This ID number is also printed at
the top of reports obtained with a local printer.
Printer Setup and COM 2 Setup
Access Level Required: OPERATOR
Pressing either key places a green selection boxa around
the first changeable parameter. Use the ▲ and ▼ keys
to place the selection box around the desired parameter
to be changed. With the selection box around the de-
sired parameter, press the ENTER key. A dialog box is
displayed permitting data entry.
68
COMMS SCREEN
Printer Baud Rate
Define the baud rate at which the panel shall commu-
nicate to the printer.
Printer Data Bit(s)
Define the number of data bits with which the panel shall
communicate to the printer.
Printer Parity Bit(s)
Define the number of parity bits with which the panel
shall communicate to the printer.
Printer Stop Bit(s)
Define the number of stop bits with which the panel shall
communicate to the printer.
COM 2 Baud Rate
Define the baud rate at which the panel shall commu-
nicate through the modem port.
COM 2 Data Bit(s)
Define the number of data bits at which the panel shall
communicate through the modem port.
COM 2 Parity Bit(s)
Define the number of parity bits at which the panel shall
communicate through the modem port.
FORM 160.55-O1 (920)
00478VIP
YORK INTERNATIONAL